Plastering & Rendering Questions

Floor to wall join
Plastering & Rendering  •  3663 views  •  14 answers

Do I need Skirting Boards? Is wall plaster durable enough if I am mopping the floor everyday and skimming the side of the wall?

Crack in Ceiling
Plastering & Rendering  •  3621 views  •  9 answers

How much will cost to dig out and refill using wire mesh for added support and strength

What to do with wood chip wall papered ceiling? Replace it?
Plastering & Rendering  •  3612 views  •  5 answers

Hello! May I please have some advice? We have a 3 bedroom flat which is entirely covered by woodchip wall paper (including the ceiling) We’re in the process of removing it all but I’m not sure which way is the best/wise for the ceilings. If I take the wall paper …

How to seal Artex for painting?
Plastering & Rendering  •  3283 views  •  0 answers

Hi, need some advise and guidance. The builders who built my now ex council property didn’t seal the Artex ceilings so I come along with paint brush and Artex flakes off. What can I do to seal Artex as ceilings need a repaint.

Bumpy, stretch mark looking plaster
Plastering & Rendering  •  3263 views  •  15 answers

We had three bedrooms plastered. Noticed today the walls in one room are bumpy, don’t look straight, marks on them and odd hard bubbles! Why has this happened? Plaster or plasterer?

Is there a time limit for rendering?
Plastering & Rendering  •  2979 views  •  23 answers

My neighbour has built an extension a few feet away. My view from my kitchen window is now an ugly brick wall. It was supposed to be rendered. This is now over 3 years and is still the same. Is there a time limit for rendering

Bonding
Plastering & Rendering  •  2858 views  •  0 answers

I made good around sockets with bonding but made it flush with wall leaving no depth for finish coat it's only a small area so what best way take back bonding to allow 2mm for finish coat

Damaged a newly plastered (skimmed) wall
Plastering & Rendering  •  2849 views  •  13 answers

I have damaged a wall that has recently been skimmed but a wooden shelf bracket had been left on before the job and it was plastered around, this was then removed from the wall and has left a big section unplastered. Does the whole wall need to be re skimmed …

Scratch coat.
Plastering & Rendering  •  2537 views  •  7 answers

I am starting applying a scratch coat to a brick wall. I have cleaned the wall and wet it ready to start. I am using sand and lime mortar. It doesn’t seem to be sticking to wall and falls off and sometimes sticks to trowel. Not sure what the problem …

Unfinished fireplace plastering
Plastering & Rendering  •  2359 views  •  20 answers

Our fireplace installer has skimmed the front of our chimney in the living room, but didn't skim the sides. The rest of the living room has been done a few weeks previously, but the on the advice of our plasterer chimney was left as it needed to be done in …