Plan design & build Ltd is an established locally approved building firm working with local architects we deliver a very high standard of work with every master trade discipline supplied.
We are proud members of the National association of building contractors (NABC)
Full project management provided
At Plan Design & Build Ltd, we pride ourselves on being builders and contractors that are synonymous with high quality, skilled craftsmanship. We provide a full range of building services in Bedford & surrounding villages , from renovation to restoration and site management. No matter how large or small your project is, our approach is always the same always focused, professional and with true attention to detail.
•I personally have 35 years on site experience & am registered as a multi disciplined Master tradesman
•I am a Proud member of the NABC
This is a select master tradesmen members invitation only guild the NABC membership stands for
( The national association of Builders confederation )
•Gold card CSCS construction scheme registered tradesman
•I am Fully trained in site & project management NVQ lvl 3 with merit & distinction
•I am City & Guilds NVQ level 2 plumbing & heating qualified
•I am an Unvented & Vented hot water registered installer
•I am a water regulations qualified plumber
•Our electrician is certified Part P qualified & NIC registered
•Our Gas safe heating engineer is Gas Safe certified
•Our Oftec certified heating engineer is also LPG registered as an installer
•Our Airconditioning engineer is F Gas certified & a registered installer
•Our bricklayers all have City and Guilds with distinction.
All our tradesmen are some of the best in the business , proven & time served with over 35 years experience within the construction industry you are assured you are instructing the professionals when choosing Plan design & build Ltd
There may be a service valve on the pipe work that serves the existing tap , if there is not then its advised to request a full bore one is installed upon the new outside tap being fitted along with an internal drain off valve so to avoid this issue in the future re maintenance.
a competent plumber should be able to locate the boundary water meter & isolate the existing out side tap & then be able to re new your existing stop cock as well , hope this helps & regards ric
Unless you are a detached property that is isolated many drains are shared this could be the cause & you could be looking for something that is unrelated to your own property,
hope this helps , regards ric
Sometimes the float valves can calcify & stick in hard water areas, with being out side & not in frequent use this is quite common. the valve may just need attention or a replacement , a competent plumber will be able to diagnose the issue via a maintenance visit ,
hope this helps , regards ric
plan design & build ltd
A maintenance visit will be required , a competent time served plumbing & heating engineer will fire up the heating system & close each radiator apart from 2 on the 1st & ground floor on the system , if its diagnosed at cold spots then on older systems this is where sludge builds up & restricts the flow & return course of the heating through the radiators , air locks are also common once works & alterations have been carried out , automatic air vents on towel warmers are recommended to aid the air escaping from the system as towel warmers are normally the higher points of heating systems on existing installations , a competent plumbing & heating engineer will be able to diagnose & remedy this , if a new system then its more than likely an air lock , the heating will need to be rebalanced after the remedial works have been actioned , hope this helps