Electrical fitting jobs in Burnham-on-Sea

Fill any gaps you have in your schedule.
Tradesman Start

Electrical fitting Jobs in Burnham-on-Sea (completed jobs only)

light fittings
Electrical fitting job 18 miles from Burnham-on-Sea in Barry
Strip lighting in kitchen one flashing intermittently possible starter unit or strip light needing replacement also lightbulb holder housing has become brittle and fallen away preventing light bulb being held in position
small electric job
Electrical fitting job 28 miles from Burnham-on-Sea in Newport
ceiling fan switch replaced in Bathroom and kitchen, electrics added to bathroom and outdoor socket to be fitted.
Replace extractor fan
Electrical fitting job 22 miles from Burnham-on-Sea in Bristol
Replace bathroom extractor fan which is in the attic. Length of vent tube (which we have) also needs to be replaced.
Fit a new light in living room
Electrical fitting job 31 miles from Burnham-on-Sea in Blackwood
Fit a new light in the living room
Install extractor fan
Electrical fitting job 38 miles from Burnham-on-Sea in Ebbw Vale
Kitchen is in need of an extractor fan
Replace ceiling mounted pull cd switch for electric shower.
Electrical fitting job 40 miles from Burnham-on-Sea in Abergavenny
Small ensuite shower / bathroom. Ceiling pull cord for shower has jammed/ failed and needs replacing.
Remove and refit new security light
Electrical fitting job 33 miles from Burnham-on-Sea in Pontypool
Security light has stopped working, I would like to replace it
Electric socket outside
Electrical fitting job 23 miles from Burnham-on-Sea in Bristol
Exterior electrical socket to be installed
Change two light fittings
Electrical fitting job 28 miles from Burnham-on-Sea in Bath
Change kitchen light fittings in two separate flats (in the same building).
Electrical works
Electrical fitting job 31 miles from Burnham-on-Sea in Thornbury
Need 4 external security lights replacing. None of the three spotlights in the en suite work.
Fitting exterior light.
Electrical fitting job 25 miles from Burnham-on-Sea in Yeovil
Exterior light to be fitted to outside of garage. Garage has interior light already and two available electrical sockets. Electrical cabling for exterior light would need to be supplied.
Connect underfloor heating thermostat to mains
Electrical fitting job 46 miles from Burnham-on-Sea in Malmesbury
The bathroom in our top floor flat is being refurbished. Insulation boards and an under-tile heating cable have been laid and are ready for testing and connection to the mains. The cable is still exposed and has not been sealed in or tiled over yet. The cable was attached to fibreglass matting but the shape of the bathroom made the matting unusable, so the cable was detached from the matt and laid on its own, but following the manufacturer’s instructions on laying loose portions of the same cable. All our existing circuits run from a consumer unit, through the roof space and down the internal partition walls which are all metal stud and plasterboard. We have roof space access if we need to run a new circuit back to the consumer unit which is approximately 4 metres away from the thermostat at the opposite end of a corridor. However the consumer unit is on an exterior wall and so the roof space access above it is very restricted. It’s tight to the eaves and enclosed by a fire barrier. It would be quite tricky to get through to the consumer unit position in the roof space, with almost no room to work when you get there. Although obviously we’d prefer not to have a visible cable running down the corridor if we can avoid it. If possible connecting to an existing circuit via a fused spur would be much easier, but I don’t know if this is allowed? The heating cable is 2 square metres of 150W cable so only 300W. We have an LCD programmable thermostat and a back box for it that hasn’t been fitted yet. The heating mat cable and sensor have been run back to an approximate thermostat location outside the bathroom. At the moment the cables are just hanging out the wall, we haven’t made any cut-outs in case anything needs to move. The thermostat position is close to various existing circuits which serve the electric central heating, heating programmer, towel rail, sockets etc. What we need is someone to advise and then make a suitable connection to the mains and test the heating before we tile over it. Must be part P registered and include to issue the paperwork to building control, and sign off the warranty for the heater.
Storage Heater
Electrical fitting job 36 miles from Burnham-on-Sea in Corsham
Supply and fit replacement night storage heater.
Fitting neon strip in garage
Electrical fitting job 35 miles from Burnham-on-Sea in Westbury
points and swiches in kitchen
Electrical fitting job 41 miles from Burnham-on-Sea in Dursley
New kitchen/utility room needs 5 extra double points 2 isolating switch points for cooker and 5 lights and switches wired. I will carry out wall chasing for trunking and making holes in wall for boxes, so just need wiring connected and certified so must be Part P.
Rewire upstairs lighting
Electrical fitting job 26 miles from Burnham-on-Sea in Caerphilly
Electrical fitting job 29 miles from Burnham-on-Sea in Pontypridd
Need a quote for rewiring lights in a 2 bed house.. don't need the sockets doing.. 6 lights in all.
2 wall heaters and door intercom not working
Electrical fitting job 157 miles from Burnham-on-Sea in Manchester
2 wall heaters - that lay back to back on each side of a wall - will not turn on. This issue has occurred before and at that time, it was a broken wire to the main fuse box (close by). Also, the intercom buzzer doesn’t work in the upstairs unit but again, this happened before and the issue was a wire connecting to the fuse box.
Replace isolator switch on hot tub
Electrical fitting job 113 miles from Burnham-on-Sea in Hinckley
Corroded isolator switch feeding hot tub needs replacing
Power point to boiler dead so might need new wire
Electrical fitting job 158 miles from Burnham-on-Sea in Salford
The switch to turn my boiler on not working. Think it might need a new wire.