Lc Driveways Limited

Hi because you have the yellow lines out side of you property
you will have to check with the local council
they may not drop the kerb
the average cost of a new driveway in block paving is around a 100 pound per square meter depending on size plus drainage is very important you may need a soakaway

The builder should have not finish that high with the block paving driveway
just so you can get the rain water to run away from the property.
that is the wrong way
when making any new driveway you are restricted by damp course levels air vent witch allow the air to go though
you can not go above should be 150mil below
you should always set a string line to see what is the best way for the rain water to flow and making sure you finish well below damp course

Hi mistakes can happen
maybe you or the builder didn't no that there was going to be clay pips

the builder should have been more careful when digging the driveway

the builder should have fixed the pipes before continuing
that's what public liability insurance is for
every builder should have it when doing this work
he sounds like a cowboy to be honest
how could you finish the driveway knowing that you have done serous damage

Hi when laying sandstone you should lay them on a strong wet bed of concreat morta
i always paint the back of the slabs with sbr
and put some in the mixer
it's a good to make the slabs stick and make the concreat rapid
also i yous half soft sand and half shap sand gives a nice smooth stickey mix

if the slabs are all lose and bad mix underneath they do not deserve to be paid

you need a professional that knows what he is doing

always to your home work before giving the job
to make sure you have the right people for the job